HotelInfantesAgres - Together we solve school questions. Logo

Questions in engineering

[Homework Help] The most common hazards associated with pneumatic tools are: a) electrocution b) struck-by-flying-object c) caught-in-machinery d) pinned-between hazards.

[Homework Help] Why do some technicians recommend using a separate refrigerant tank when purging hoses? A. To maintain pressure levels B. To preserve coolant C. To continue refrigerant flow D. To preserve system charge

[Homework Help] Lisa is picking up a tridem-axle trailer. What is the semitrailer tridem axle's maximum axle spread? A. 1.85 m B. 2.8 m C. 3.7 m

[Homework Help] Which of the following devices help prevent high-pressure nozzle release and protect pneumatic tool operators in the event of a high-velocity nozzle ejection? A. Appropriate head, eye, and face protection B. Safety clips C. Manual operating valves D. Diffuser nuts and tip guards

[Homework Help] A(n) __________ is a cutting tool consisting of a power-operated wheel with rough grains held together by organic or inorganic bonds. a) guillotine cutter b) electric drill c) power saw d) abrasive wheel

[Homework Help] Select the best answer for the question. 11. Leak detectors can be used with systems that are charged only with nitrogen. A. Corona discharge electronic B. Ultrasonic C. Heated diode electronic D. Infrared

[Homework Help] Select the best answer for the question. What's the minimum velocity in a horizontal suction line for most systems? A. 3,000-3,500 ft per minute B. 500-750 ft per minute C. 750-1,000 ft per minute D. 1,000–1,500 ft per minute

[Homework Help] Which of the following systems would be most likely to produce a power waveform that would require a true RMS meter to accurately measure? A. A shaded-pole motor controlled by a relay B. An electric strip heater controlled by a contactor C. A three-phase motor controlled by a variable-frequency drive D. An incandescent light controlled by a toggle switch

[Homework Help] Place the steps of flaring copper tubing in the correct order: A. Turn the handle until the tool completes the process and loosen the clamps. B. Center the flaring cone over the pipe and tighten. C. Cut the copper tube with a tube cutter. D. Smooth the cut-in. E. Stick the pipe into the correctly sized clamp and tighten.

[Homework Help] Area [tex]A=30 m \times 12 m=360 m^2[/tex] Depreciation Factor [tex]=1.3[/tex] Utilisation Factor [tex]=0.5[/tex] Assume mounting height [tex]=6 m[/tex] Gross lumens required [tex]\phi=\frac{A \times E}{U F \times M F}[/tex] [tex]\begin{array}{l}=\frac{A \times E \times D F}{U F} \\=\frac{360 \times 50 \times 13}{0.5}=46800 lcmen\end{array}[/tex] If 100 watts are used, # of lamps required [tex]=\frac{46800}{1615}[/tex] [tex]=29 lamps[/tex]